Can't connect to T7-Pro using WiFi | LabJack
 

Can't connect to T7-Pro using WiFi

4 posts / 0 new
Last post
alon.y
alon.y's picture
Can't connect to T7-Pro using WiFi

Hello,

I have used Labjack for some time using only Ethernet connection, and I'm checking the possibility to use Labjack trough WiFi but having problems using it.

I connect a Labjack and a computer to a router. In Network Settings, i tried to use 'Manual'. I filled the fields and got 'Connection Status': Associated. The initial signal strength is -42db.

Then, when i go to 'Device Selector' and choose 'Wifi'( Over USB connection) I get this error: LJME_Device_Not_Found (1227)

Now, when i'm trying to connect using DHCP, I get 'Connection Status: 'Associated' and in 'Device Selector' I'm not getting any errors.

When i open LJStream, I get LabJack Error #1314 LJME_NO_DEVICES_FOUND occurred at LJM_OpenS.vi .

Thanks for your help.

LabJack Support
labjack support's picture
Can you ping the T7's wifi IP

Can you ping the T7's wifi IP address?

The WiFi Setup section of this page may be helpful:

https://labjack.com/support/app-notes/wifi-and-ethernet-t7-t4-t7-pro

Make sure you're running the latest software:

https://labjack.com/support/software/installers/ljm

Also, please update to the latest firmware using Kipling.

jason4
jason4's picture
I have successfully connected

I have successfully connected to my T7 Pro with LJLogM.  I followed the instructions from this page:

https://labjack.com/support/app-notes/wifi-and-ethernet-t7-t4-t7-pro

Using the TCPOpen Testing tool, I connected using the Specific open instructions.

See attached.  

I then updated the LJLogMopen.cfg file as shown:

[Main]

DeviceType=t7

ConnectionType=wifi

Identifier=10.0.8.47

LabJack Support
labjack support's picture
Glad you got it working. 

Glad you got it working.  Sounds like your network has condition 2C from the bottom of our basic networking page:

https://labjack.com/support/app-notes/basic-networking-troubleshooting