Can the LJTick-DAC be connected to the MIO digital outputs of the T7 (through the CB37 expansion board)?
All other digital output pins headers are: VS, GND, DACA, DACB
However the MIO0-1 lines are VM+, VM-, DACA, DACB
and MIO2 is DACA, PIN2, PIN20, AGND
.png%3Fitok=PHGBxf6M "EEV Blog Reviews LabJack T7-Pro & Software Tools")
.jpg%3Fitok=B1YcuDFK)
.png%3Fitok=Ybt-OlgU "LabJack + JEDI One Can Create a Powerful Distributed DAQ Ecosystem")
Yes, all 23 DIO including the MIO lines can be used with the LJTick-DAC, but the MIO screw-terminals on the CB37 are not layed out for an LJTick-DAC so you would have to wire it some other way.
When LJTick-DAC is connected to FIO2-3 we use TDAC2-3 to set voltage on DACA-B
What is the term to use when LJTick-DAC is connected to the MIO digital outputs of the T7 ?
I didn't found TDAC22 for MIO2 in kipling ?!!
TDAC22 doesn't exist because using MIO2 is not supported with the LJTick-DAC. MIO0 and MIO1 are supported though.
TDAC0-19 are most convenient. Can you use any of those instead?